There are lots of advantages of having drywall construction in your home. four. Grab onto the metal spring tabs with needlenose pliers and snap them off below the drywall surface. Bond new plaster to old by brushing the area, and some surrounding wall, with a 5:1 PVA resolution – 5 elements water to 1 half PVA. Whereas the compound is still moist, place a strip of fiberglass tape over the seam, bridging the hole between the ends of the existing tape (picture 4). Use a putty knife to softly flatten wrinkles and to bed the tape into the compound.
Retape the joint following the methods proven in Step 1. Crease the paper tape down the center so it fits into the corner simply (Photograph 2). It is troublesome to unfold compound easily on one aspect of the nook with out marring the opposite aspect. Often, the injury is confined to a short section that can be lower away and replaced.
Use a utility knife to cut vertically alongside the drywall, connecting the highest and bottom cuts from the hacksaw on the left and right sides. Use a utility knife to scrap away the drywall until the screw is uncovered. Immediately apply a lightweight coating to the topside of the tape, tapering it out onto the wall.
Let the patch dry and apply a second coat of compound if wanted. Patching drywall, whatever the measurement of the opening, is fairly easy with the correct tools and methods. Sink the screw head slightly below the surface of the drywall so it can be lined with spackle. Match the gypsum into the brand new hole and press the paper edges coated with joint compound into place alongside the outside fringe of the outlet.
2. Use a sharp utility knife to carefully lower away the mesh section that is masking the electrical box. This method eliminates the necessity to lower the prevailing drywall in a straight line and offers the brand new drywall a stronger anchor. Embed the tape and canopy the complete space with a thin coat of drywall compound, and complete the repair as described in the steps above.